3-25
Cut Out Data with Registration Mark
3
Useful Function
5
Set with the jog key or .
• Press the key. And the plotter moves
to the next scale compensation setting.
• If [MARK DETECT] is set to [2ptA], the display for
inputting the B length will not appear.
• If [MARK DETECT] is set to [1pt], the scale compensation setting display will not appear
but the origin point will be displayed. (Step 7)
6
Press the key after
completing the settings.
• The registration mark detection will be started.
• See "Setting the Number of Registration Mark
Detection" （ P. 3 -1 9 ） for the number of
registration marks.
• In case the plotter cannot detect any registration
marks, it displays “Error 36 in the registration mark
detection” on the display. Set the sheet again.
7
Set the origin.
• After the detection of the registration marks, the
display will show the available cutting area and
then return to local mode.
To Next Page
Loading...
