Expand the cutting (plotting) area
3-40
5
Press the key.
6
the jog keyPress or key to
select “ON.”
7
Press the key.
8
Press the key twice for terminating this function.
Set EXPANDS function to “OFF”.
• When the Expand mode is set to ON, paper jam can occur if excessive pressure is applied to
the sheet.
• If axis compensation is not performed, the cutter blade can run out of the sheet and may cause
a paper jam. A cutter blade having run out of the sheet may damage itself or the plotter.
• The cutting quality of the areas that come in contact with the pinch rollers will be lowered.
• If a pinch roller comes in contact with a registration mark during its detection, the registration
mark may not be detected properly.
• Once the Expand function is set after sheet detection, be sure to perform sheet detection
again.
Follow the Steps 1
to 5 of "Set the
EXPANDS function
to ON."
Press the jog key
to select
“OFF.”
Press the
key.
Press the
key twice.
To Next Page
Loading...
