MIMAKI CJV30 Series User Manual

© 2009 MIMAKI ENGINEERING CO.,LTD.
4.3.2 P.1
1
2
3
4
5
6
7
8
R.1.1
Maintenance Manual > Adjustment Items > Mechanical Adjustment > Adjustment of the Mounting Location for the Cutter
Model CJV30/TPC Issued 2008.08.04 Revised 2008.09.17 F/W ver. 1.20 Remark
1.1
Rev.
4.3.2 Adjustment of the Mounting Location for the Cutter
 Function
Adjust the cutter location in the back-and-forth direction by moving the cutter unit back and forth while visually
checking the location.
 Procedure
1. Loosen the screws shown in the diagram to the degree whereby
the cutter unit can be held loosely.
2. Push down the clamp lever.
3. Push down the cutter blade and adjust the back-and-forth loca-
tion of the unit so that the tip of the cutter blade is located in the
middle of the groove. Then tighten the loosened screws.
4. Move the head unit manually and push down the cutter blade
assy at each right, center and left end on the platen, to check
back-front positioning.
Locate the tip of cutter blade
in the middle of groove
Loosen
Cutter Unit
Be sure to make the adjustment while the clamp
lever is lowered.
Hold this
down.
Tighten screws after back-
and-forth adjustment
Check each of three locations.
On rare occasions, the blade comes out of the slot
because of assembly errors or fluctuation in part
accuracies. In such a case, adjust again to the back-
front optimum position where the blade is always in
whole slot on the platen.

MIMAKI CJV30 Series Specifications

General

Cutting Function	Yes
Interface	USB 2.0, Ethernet
Power Supply	AC 100-240 V, 50/60 Hz
Print Head	Piezoelectric Inkjet
Resolution	1440 dpi
Print Resolution	Maximum 1440 dpi
Printing Technology	Solvent Inkjet
Print Speed	Up to 17.5 m²/h
Ink Type	Solvent Ink
Ink Colors	CMYK, White
Maximum Print Width	1610 mm (CJV30-160 model)
Media Width	1372 mm (54 inches)
Media Thickness	Maximum 1.0 mm
Cutting Force	500 g
Weight	180 kg (CJV30-160 model)