This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow of printing ......................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media .............................................2-4
Adjusting the Head Height .......................... 2-4
Adjusting the Position of the Pinch Roller
According to the State of a Media ............... 2-5
Maximum Print Area/Cut Area .................... 2-8
Notes When Using media Holder ................ 2-8
Setting a roll media ..................................... 2-9
Take-up device .......................................... 2-12
Setting leaf media ..................................... 2-12
Changing the printing origin ...................... 2-14
Preparing for the Heaters ............................2-14
Changing the Temperature Settings for
the Heaters ................................................ 2-14
Test Printing ................................................2-15
Test Printing .............................................. 2-15
Head Cleaning ............................................2-16
About head cleaning ................................. 2-16
Perform head cleaning depending on
the test printing result ................................ 2-16
Setting of Media Correction .........................2-16
Setting of Media Correction ......................2-16
If the Positions of Dots Shift... .....................2-17
Printing Data ...............................................2-17
Starting a Printing Operation .....................2-17
Stopping a Printing Operation ....................2-18
Deleting Received Data (Data Clear) ........2-18
Cutting a media ...........................................2-18
Workflow of cutting ......................................2-19
Installing Tools ............................................2-20
When a Cutter Is Used ..............................2-20
How to Install a Ballpoint Pen ....................2-21
Setting the tool conditions ...........................2-23
Kinds of the Tool Conditions ......................2-23
Select the tool condition .............................2-24
Set the Tool Conditions .............................2-24
Test Cutting .................................................2-25
Cutting Data ................................................2-25
Setting the origin ........................................2-25
Start cutting ................................................2-26
Stopping a Cutting Operation
(Data Clear) ...............................................2-26
Cutting a media ...........................................2-26
Chapter 2
Basic Operations
To Next Page
Loading...
