MIMAKI JV5 Series User Manual

This chapter
describes procedures and setting methods for ink and media preparation, tool installation
for cutting, and printing and cutting.
User Type for Printing ................................ 2-2
Settings That Can Be Registered in User
Types .......................................................... 2-2
Using the Registered User Types ............... 2-2
About Tool Conditions during Cutting ..... 2-3
Tool Condition Types and Their Selection
Method ........................................................ 2-3
Registering a Tool Condition ....................... 2-4
Improving Cutting Quality ............................ 2-6
Operation Flow............................................ 2-7
Turning the Power ON/OFF........................ 2-8
Turning the Power ON ................................ 2-8
Turning the Power OFF ............................... 2-9
Installing Tools.......................................... 2-10
When a Cutter Is Used .............................. 2-10
Exchanging Tool ....................................... 2-13
How to Attach a Ballpoint pen ................... 2-14
Setting a Medium ...................................... 2-15
Adjusting the Head Height ........................ 2-15
Adjusting the Position of the Pinch Roller
According to the State of a Medium .......... 2-17
Roll Stopper .............................................. 2-22
Maximum Print Area/Cut Area .................. 2-23
Notes When Using Medium Holder ........... 2-24
Setting a Roll Medium ............................... 2-25
Take-up Device ......................................... 2-29
Setting a Leaf Medium .............................. 2-31
When Changing the Origin ........................ 2-33
Test Printing .............................................. 2-35
Perform test printing with the normal test
pattern ........................................................2-36
Perform test printing with the test pattern
for checking white ink ................................2-37
Check warning of white nozzle status
(Only when using SS21 white ink) .............2-38
Head Cleaning ........................................... 2-39
About head cleaning ..................................2-39
Perform head cleaning depending on
the test printing result ................................2-39
Perform spot color maintenance ................2-40
Test Cutting ............................................... 2-43
Preparing for the Heaters ......................... 2-44
Changing the Temperature Settings for
the Heaters ................................................2-44
Checking the Heater Temperature ............ 2-45
Printing Data.............................................. 2-46
Starting a Printing Operation .....................2-46
Stopping a Printing Operation ....................2-47
Deleting Received Data (Data Clear) ........2-47
Data Cutting............................................... 2-48
Starting a Cutting Operation ......................2-48
Stopping Cutting in a While .......................2-48
Restarting a Cutting Operation ..................2-48
Stopping a Cutting Operation (Data Clear) 2-49
Removing the Cutter Unit Temporarily ......2-49
Cutting a Medium ...................................... 2-50
Chapter 2
Basic Operations

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English