MIMAKI JV5 Series User Manual

3-3
About User Types
3
Extended Functions – Printer –
List of Functions to Be Set in User Types
This section describes the overview of each function to be set and set values that can be registered in user types.
The underlined has been set as default.
Function Name Set Value Overview
PINCH
ROLLER
(P.3-5)
ENDS HIGH/MIDDLE/LOW Used to set the pinch roller pressure.
INNER HIGH/MIDDLE/LOW/OFF
No.
2 to 7 Used to set the number of the pinch roller at
the left end of the medium.
MEDIA COMP. ( P.3-8) -255 to 0
to 255 Used to print a pattern for correcting a media-
feeding rate and correct it.
DROP. POS CORRECT ( P.3-10) -40.0 to 0
to 40.0 Used to adjust the dot position in go and
return printing.
HEATER
( P.3-12)
SET TEMP. PRE
HEATER
OFF/ 20 to 50°C
(OFF/ 68 to 122°F)
Used to set heater conditions.
PRINT
HEATER
OFF/20 to 50°C
(OFF/68 to 122°F)
POST
HEATER
OFF/20 to 50°C
(OFF/68 to 122°F)
SET TIME STANDBY (NONE
/0 to 90 min
by the unit of 10 min)
OFF TIME (NONE
/0 to 90 min
by the unit of 10 min)
PRINT
MODE
( P.3-16)
DRAFT QUALITY STD
/ FAST / FINE Used to set printing quality and a printing
direction.
FINE QUALITY STD
/ FAST / FINE
SCAN DIRECTION Bi-D / Uni-D
LOGICAL SEEK ON/OFF
WHITE LAY PRINT OFF
/ON (LEVEL1 to 3)
INK LAYER ( P.3-27) 1
to 9 Used to set the number of layers to which ink
is applied.
DRYING
TIME
( P.3-21)
SCAN 0.0
to 19.9 sec Used to set the time for ink to dry.
PRINT END 0
to 999 sec
AUTO CUT ( P.3-27) ON/OFF
Used to cut the media automatically after
printing.
PRE-FEED( P.3-27) ON/OFF
Used to feed a medium back and forth before
printing.
When a sticky medium is used, select ON.
COLOR PATTERN ( P.3-27) ON/OFF
Used to print a color pattern on the right edge
of a medium.
REFRESH ( P.3-27) LEVEL 0 (Long interval for
refreshing) to 3 (Short interval
for refreshing)
Used to refresh the print heads during
printing.
VACUUM ( P.3-27) OFF / STANDARD
/ WEAK /
LittleWEAK / STRONG
Used to set the ability to adsorb a medium.
FEED SPEED LEVEL ( P.3-27) 10 to 100
to 200%
10%........6 mm/sec
100%......60 mm/sec
200%....120 mm/sec
Used to change the media-feeding speed
during printing, etc.

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English