MIMAKI TS100-1600 - Wiper Cleaner Replacement

Chapter 4 Maintenance
105
7
Mount a new wiper.
Lug
8
Once replacement is complete, close the cover, then press the [ENTER] key.
• The wiper usage count is reset.
Wiper Cleaner Replacement
Replace with a new wiper cleaner once a year.
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [Carriage Out] > [Move To Platen Right End], then press the [ENTER] key.
• The carriage moves over the platen.
3
Open the front cover.
4
Remove the fittings.
• Pull out the fitting by holding the protrusion.
• Take care to avoid losing the rubber seal.
1
2
1
5
Remove the wiper cleaner.
• Pull it forward to detach it.
1
2
4