MIMAKI TS100-1600 - Loading the Roll Media

Chapter 2 Printing
56
Loading the Roll Media
1
Raise the clamp lever.
2
Move the rear left roll holder to the roll setting position.
• Unscrew the roll holder retaining screw before moving.
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
R o l l H o l d e r
S e t P o s i ti o n
3 I nc h R ol l M e d i a
2 I nc h R ol l M e d i a
Set the roll holder reference line within the area
indicated by the arrows as shown below.
Setting position for 3-inch paper core
Setting position for 2-inch paper core
Reference
3
Tighten the retaining screw on the rear left roll holder.
4
Place roll media on the roll media hanger.
5
Insert the paper core of the roll media on to the rear left roll holder.
• Push in until the paper core moves no farther.
6
Insert the rear right roll holder into the paper core.
• Unscrew the roll holder retaining screw before moving.
7
Tighten the retaining screw on the rear right roll holder.