Chapter 2 Printing
57
8
Insert the media.
• Insert into the gap between the pinch rollers and the grit rollers.
• Inserting the media at an angle allows smooth insertion without catching or sticking.
9
Lower the clamp lever.
• Hold the media with the pinch roller and grit rollers.
10
Move to the front of the machine and open the front cover.
11
Raise the clamp lever and pull out the media.
• Make sure the media does not fall to the rear.
• Adjust the rear roll holder position so that the media does not cover the right-hand slit line
on the platen. Movement at an angle may result in damage to the print head.
Slit line
Media
Media holder
• The areas extending 5 mm from both sides of the media are margins.
12
Gently pull out the media and stop at the position where it is gently locked in place.
13
Check how far the media was pulled out.
• Pull the front edge of the media gently at several points to confirm that the media was pulled out
by the same amount.
2
To Next Page
Loading...
