Chapter 3 Settings
84
Item
Setting
*1
Details
Reset - Initializes the details set.
*1. The default settings are shown underlined.
Event Email Function Settings
An email can be sent to a specified email address when an event (e.g., print start, print end, and abort)
occurs.
• SSL (Secure Socket Layer) encoding is not supported.
• Connect the LAN cable to use the event mail function.
"Using a LAN Cable"(P. 31)
DISCLAIMERS
• Internet communication charges for email notifications, etc. are the responsibility of the customer.
• Event emails may not be delivered if problems arise with the Internet setup or equipment. Mimaki
rejects all liability for damages resulting from delivery failure or delay.
Transmit Test
1
In LOCAL mode screen, select [MENU] > [Machine Setup], then press the [ENTER] key.
• The Machine Setup menu is displayed.
2
Select [Event Mail] > [Transmit Test], then press the [ENTER] key.
3
Press the [ENTER] key.
• The transmission results are displayed.
• An error code will be displayed if the test email transmission is unsuccessful. Refer to the error
code list and take appropriate action.
㼀㼞㼍㼚㼟㼙㼕㼠㻌㼀㼑㼟㼠
㻲㼍㼕㼘㼑㼐䚷䚷䠖㻌㻌㻝㻌㻞㻌㻟㻌㻠㻌㻡
• Emails may not necessarily be delivered even if they have been sent. Check the terminal
receiving the email for spam email filters.
• For more information on server settings or other topics, contact your network administrator
or service provider.
4
Press the [ENTER] key once the test is complete.
l
Error Code List
Error code Likely cause Corrective action
10 Network connection error • Check to confirm that this machine is connected to a
network.
• Check the IP address for this machine.
• Check if the network setup allows this machine to use
DNS.
To Next Page
Loading...
