MIMAKI TS100-1600 - Preparing RIP Data

Chapter 2 Printing
67
2.8 Preparing RIP data
The explanation here applies to MIMAKI RIP software (RasterLink).
• If using TxLink, refer to the TxLink operating manual.
• Prepare suitable image data for printing.
1
Launch RasterLink.
• Click the icon on the PC desktop.
2
Select the image data to print.
(1) Select [File] > [Open].
(2) Select the desired image data, then click [Open].
• If multiple printers are registered, select TS100-1600 in "Printer Name".
3
Select the image data imported.
• The image is displayed in the tab for TS100-1600 selected in "Printer name".
2