Chapter 4 Maintenance
114
4
Unscrew the screw, then open the carriage cover hatch.
5
Replace the media cutter.
(1) Unscrew the cutter screw.
(2) Remove the cutter.
(3) Mount a new cutter.
(4) Tighten the screw to clamp the cutter.
6
Close the carriage cover hatch, then retighten the screw.
7
Once replacement is complete, close the cover, then press the [ENTER] key.
• When disposing of the product, contact an industrial waste disposal operator or dispose of the
product in accordance with the local laws and regulations.
Media Edge Guide Film Replacement
Replace the media edge guide film if it is creased or worn.
1
Remove the media from the take-up unit.
2
Remove the media edge guide film from the media edge guide.
To Next Page
Loading...
