MIMAKI TS100-1600 - Setup Menu

Chapter 3 Settings
74
3.1 Setup menu
Print conditions (settings 1 to 4) can be saved in advance for specific media.
l
Menu List
The user can select to prioritize the settings on the machine or the settings on the PC. Setting individual
menus to "Host" prioritizes PC settings. To prioritize settings for this machine, select a setting other than
"Host".
• For more information on how to specify RIP software, refer to the RIP software operating
manual.
Item Setting Details
*1 *2
Feed Comp. -9999 to 0 to
9999
- Corrects the media feed amount.
• Print a pattern and enter the correction amount.
Drop.PosCorrect - - Corrects the drop position for bi-directional printing.
(Resolution) All/360std/720
std/720hi
- Select the resolution to be corrected. When “All” is selected,
correction patterns for all resolutions will be printed.
(Correction
value)
-40.0 to 0 to
40.0
- Check the pattern and enter correction values.
Auto Correct - - Detects a correction pattern with the sensor and automatically
corrects the drop position (automatic correction function).
• Check to confirm that the media does not lift up.
• Load white and clean media.
• Synthetic paper or cloth media may not be detected.
• Do not send the RIP data from the PC during pattern
printing.
• If automatic correction is unsuccessful, correct the position
manually. [MENU] > [Setup] > [Feed Comp.] or
[Drop.PosCorrect]
Feed Comp. - -
Drop.PosCorrect - -
(Resolution) All/360std/720
std/720hi
- Select the resolution to be corrected. When “All” is selected,
correction patterns for all resolutions will be printed.
(Correction
value)
-40.0 to 0 to
40.0
- Check the pattern and enter correction values.
Logical Seek HOST/ON/
OFF
OFF Sets the range of carriage movement.
• OFF: Machine size area
Unidirectional print Bi-directional print
Carriage movement