Chapter 3 Settings
75
Item Setting Details
*1 *2
• ON: Print data area
Unidirectional print Bi-directional print
Print data
Carriage movement
DRYING TIME - - Sets the ink drying time.
Scan HOST/0.0 to
9.9 sec
0 Sets the time to stop the carriage each time the carriage
scans.
• In the MIMAKI RIP software (RasterLink), it is indicated as
the “drying time after each scan”.
PRINT END HOST/0 to
120 min
0 Sets the stop time after printing. After the set time passes, the
next data is printed.
• The Mimaki RIP software (RasterLink) does not allow the
user to specify PRINT END. If the machine is set to
“HOST”, the time will be “0”.
Margin/Left HOST/-10 to
85 mm
0m
m
Sets the offset value from the media left and right standard
margins (15 mm).
• The left and right margins should be set to at least -5 mm
when using the media holder. This eliminates the risk of
printing on top of the media holder.
• The Mimaki RIP software (RasterLink) does not allow the
user to specify margins. If the machine is set to “HOST”,
the offset value will be “0 mm” for the left and right
margins.
Margin/Right
Vacuum fan HOST/Weak/
Standard/
Strong
Stro
ng
Sets the force with which the medium is held down.
• This can be used to prevent media jamming and print
head damage caused by the media lifting up.
Feed Speed HOST/10 to
100 to 200 %
100 Sets the media feed speed.
• Depending on print conditions, the speed may not vary for
certain settings.
• Setting to 100 % or more reduces the time required to
complete printing but may affect print quality due to
insufficient drying time.
Auto Cleaning - - Sets the conditions to perform auto head cleaning after the
preset number of files are printed.
SETUP File/Length/
Time/OFF
- Sets the conditions to perform auto head cleaning.
Interval - - Sets auto head cleaning intervals.
(File) 1 to 1,000 - Sets the interval at which the number of files is selected.
(Length) 0.1 m to 100.0
m
- Sets the interval at which the print length is selected.
(Time) 10 to 60 to
240 min
- Sets the interval at which the print time is selected.
3
To Next Page
Loading...
