Chapter 5 Troubleshooting
123
• If not, use a syringe to draw up some maintenance liquid and fill until it almost overflows
from the cap.
9
Close the front cover.
10
Set the exposure time, then press the [ENTER] key.
• Print nozzle washing starts. The elapsed time is displayed on the display.
• Cleaning is performed automatically once print nozzle washing has ended.
• If print defects (e.g., nozzle clogging, deflection) remain unresolved even after washing
the nozzles several times, contact your local dealer or our service office.
The ink has leaked out
• If an ink leak occurs, turn off the main power immediately and unplug the power cable. Then,
contact your local dealer or our service office.
The light-blocking cover comes off.
If the light-blocking cover comes loose, reattach as follows:
1
Insert the lug on one side of the light-blocking cover into the corresponding hole in the tank.
5
To Next Page
Loading...
