Chapter 3 Settings
76
Item Setting Details
*1 *2
Type Normal/Soft/
Hard
- Sets the head cleaning type.
Cleaning Check ON/OFF - Sets whether nozzle checking is performed after auto head
cleaning is completed.
MAPS4 - - MAPS: Mimaki Advanced Pass System
• This function disperses the boundaries between passes to
make feed streaks between passes less visible.
• Altering MAPS may alter the color. This function may be
less effective with certain types of images.
MAPS4 AUTO/
MANUAL
- This should normally be set to “AUTO”. When set to
“MANUAL”, the following items are displayed:
Smoothing
Level
0 to 100 % - Increasing smoothing makes streaks less visible.
Speed 50 to 100 % - Reducing speed will make streaks less visible. However,
printing will be slower.
Concentration
correction between
passes
OFF/Weak/
Medium/
Strong
- This function makes periodic concentration variations less
noticeable.
• Check by printing. Once set, does not need to be adjusted
until the print head is replaced.
Prefeed OFF/100 to
500 mm
- Sets the distance the media is fed backward and forward
before printing.
• Moving the media backward and forward prevents it
sticking to the platen and minimizes wrinkles in the media.
Setup Reset - - Initializes the details set.
*1. The default settings are shown underlined.
*2. Settings applied if no settings can be made in the RIP software (host) or if this machine is prioritized.
Changing the name of a setting type
You can change the name of a setting type. The name can include alphanumeric characters or symbols.
1
On the LOCAL mode screen, select [MENU] > [Setup], then press the [ENTER] key.
• The setting types are displayed.
2
Select Settings 1 to 4 and press the [FUNC2] key.
• The rename screen appears.
3
Enter the desired name, then press the [ENTER] key.
• The setting type is renamed.
To Next Page
Loading...
