Chapter 2 Printing
65
2.7 Correcting the Drop Position
Changing the media and print head height will also alter the drop positions. Correct the drop position to suit
the type of media used. Image defects (e.g., overlaid lines or blurred images) will result if the drop position is
not properly corrected.
Check beforehand
• Was the print head adjusted? "Adjust Print Head Height"(P. 51)
• Is media loaded? "Loading the media"(P. 53)
• Load media at least 500 mm wide. You cannot print the entire pattern if media less than 500
mm wide is used.
Drop Position Correction Procedure
Print a correction pattern, then enter the correction value. The value corrected here will also be updated on
the settings menu.
1
On the LOCAL mode screen, select [ADJUST].
width:1340mm
DATA CLEARADJUST
LOCAL
2
Select [Drop.PosCorrect], then press the [ENTER] key.
3
Select the resolution and press the [ENTER] key.
• Select the resolution to be adjusted. When “All” is selected, correction patterns for all resolutions
will be printed. "Setup menu"(P. 74)
• The indicated resolutions are those in the scan direction.
4
Check the print results.
• A correction value input screen appears.
• Enter the position where the two upper and lower lines coincide.
In this case, the drop position correction value will be "+4.0".
Media feed direction
5
Enter the correction value, then press the [ENTER] key.
• Correction value: -40 to 40
2
To Next Page
Loading...
