Chapter 5 Troubleshooting
128
Message Cause Corrective action
Wrong Ink IC • An error occurred with the
information on the ink IC
chip.
1. Check to confirm the ink IC chip was
inserted correctly. "Registering the Ink
IC Chip"(P. 42)
2. Turn off the main power and wait a while
before turning back on.
3. Replace with new ink. "When Ink End is
Displayed"(P. 37)
Replace Ink • The ink IC chip was
registered when an ink
end or ink near-end error
occurred.
• Mount new ink and register the ink IC
chip.
Error Message
Error
number
Message Cause Corrective action
04 PARAM ROM • A problem was detected
with the main PCB.
• Turn off the power on the machine
and turn it on after a while.
108 HD THERMIS [1234] • A problem was detected
with print head
temperature control.
• Turn off the power on the machine
and turn it on after a while.
108 HD CONNECT [1234] • A problem was detected
with the print head
connection.
122 CHECK:SDRAM • A problem was detected
with the SDRAM.
• Turn off the power on the machine
and turn it on after a while.
128 HDC FIFO OVER • A problem was detected
with the print head control
PCB.
128 HDC FIFO UNDER
129 Battery Exchange • The internal clock battery
is spent and must be
replaced.
• Contact your local distributor, our
sales office, or service center.
12a HDC SPEED • A problem was detected
with the print head control.
• Turn off the power on the machine
and turn it on after a while.
130 HD DATA SEQ
148 E-LOG SEQ • A log control abnormality
was detected.
• Turn off the power on the machine
and turn it on after a while.
151 Main PCB V1R2 • A problem was detected
with the main PCB power
supply circuit.
• Turn off the power on the machine
and turn it on after a while.
152 Main PCB V2R5
153 Main PCB V3R3
154 Main PCB V05
157 Main PCB VTT
158 Main PCB V36-2
15f HEAD DRIVE HOT • The COM drive has
overheated.
• Turn off the power on the machine
and turn it on after a while.
16e Main PCB V3R3B • A problem was detected
with the main PCB power
supply circuit.
To Next Page
Loading...
