MIMAKI TS100-1600 - Page 129

Chapter 5 Troubleshooting
129
Error
number
Message Cause Corrective action
171 NEW HEAD CONNECT • A new print head
connection was detected.
18a Main PCB V_CORE • A problem was detected
with the main PCB power
supply.
• Turn off the power on the machine
and turn it on after a while.
18b Main PCB V1R5B
18c Main PCB V12
18e FLS NOT COMP • A problem was detected
with the print head control.
• Turn off the power on the machine
and turn it on after a while.
18f OFSET START
18f OFSET END
1e6 PRAM Size Shortage • Insufficient memory • Turn off the power on the machine
and turn it on after a while.
201 Command Error • Data other than print (RIP)
data was received, or a
problem was detected
with the print (RIP) data
received.
1. Clear the data and resend.
2. Check the USB cable connection.
"Using a USB Cable"(P. 31)
3. Use a compliant USB cable. "USB
Connection Precautions"(P. 31)
4. Turn off the power on the machine and
turn it on after a while.
202 Parameter Error • A problem was detected
with the print (RIP) data
received.
206 Printing Mode • Print (RIP) data was
received with print
parameters that do not
allow printing.
• Change the output parameters and
profile using RIP software.
20A Driver Version • Printing is not possible
because the Mimaki driver
version is old.
• Install the latest Mimaki driver
available from:
https://mimaki.com/download/
inkjet.html
304 USB INIT ERR • A problem was detected
with the USB cable
connection.
1. Check the USB cable connection.
"Using a USB Cable"(P. 31)
2. Use a compliant USB cable. "USB
Connection Precautions"(P. 31)
3. Turn off the power on the machine and
turn it on after a while.
305 USB TIME OUT
307 MCFD File IF Error • A problem was detected
while accessing print
parameter data.
• Turn off the power on the machine
and turn it on after a while.
401 Motor X • The X motor was
overloaded.
1. Check to confirm the media is loaded
correctly. "Loading the
media"(P. 53)
2. Open the front cover and check for
anything that may obstruct carriage
movement.
3. Turn off the power on the machine and
turn it on after a while.
402 Motor Y • The Y motor was
overloaded.
403 X Current • An overcurrent error was
detected in the X motor.
404 Y Current • An overcurrent error was
detected in the Y motor.
406 Wiper Move Failure • Wiper-origin could not be
detected.
1. Clean the wiper and around the wiper.
"Wiper Cleaning"(P. 92)
2. Turn off the power on the machine and
turn it on after a while.
5