Chapter 5 Troubleshooting
130
Error
number
Message Cause Corrective action
44f Take-up Roll Sns Err • A problem was detected
with the take-up unit
sensor spindle.
1. Check to confirm the [Machine Setup] >
[ Feeding/Take-up] > [Take-up Unit]
setting is "ON".
2. Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 56)
3. Check to confirm the take-up unit switch
functions properly. "Take-up
unit"(P. 53)
48a Detect winding failure • The take-up unit is unable
to take up media.
• Check to confirm the media is
loaded correctly. "Loading the
Roll Media"(P. 56)
504 CLAMP UP • The clamp lever is lifted. • Lower the clamp lever.
505 Media Jam • The media jam sensor
was triggered.
1. Remove the media in contact with the
carriage and reload with fresh media.
"Loading the media"(P. 53)
2. Open the front cover and check for
anything that may obstruct carriage
movement.
509 HDC POSCNT • A problem was detected
with position control.
• Turn off the power on the machine
and turn it on after a while.
50a Y Org Detect Error • A problem was detected
with Y origin detection
(initialization).
50c Check Media With
Sensor
• A problem was detected
with media width
detection.
1. Check the media loading position.
"Loading the media"(P. 53)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 98)
50f L-SCALE BLACK • A problem was detected
with the linear scale.
• Turn off the power on the machine
and turn it on after a while.
516 Media Set Position R • The media was loaded
outside the range of valid
positions.
1. Check the media loading position.
"Loading the media"(P. 53)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 98)
528 Pump Motor Sensor • A problem was detected
with the pump motor.
• Turn off the power on the machine
and turn it on after a while.
549 LEnc. Count DIO • A problem was detected
with the linear scale wiring
to the DIO PCB.
• Turn off the power on the machine
and turn it on after a while.
602 Ink End • The ink has run out. • Replace with new ink.
"Replacing Ink"(P. 38)
608 Wrong Ink IC • An error occurred with the
information on the ink IC
chip.
1. Check to confirm the ink IC chip was
inserted correctly. "Registering the
Ink IC Chip"(P. 42)
2. Turn off the power on the machine and
turn it on after a while.
3. Replace with new ink. "Replacing
Ink"(P. 38)
64C NCU Error • The function is disabled
due to an error.
• Turn off the power on the machine
and turn it on after a while.
To Next Page
Loading...
