Chapter 2 Printing
58
14
Lower the clamp lever.
15
Secure the media in the media holder.
• Do not use the media holder when printing on thicker media.
16
Press , then select "Roll".
• This starts media width detection.
• If the setting for [Machine Setup] > [Media Detect] > [Detection Type] is "MANUAL", the area for
printing must be determined manually.
• If the setting for [Machine Setup] > [Media Detect] > [Media Remain] is "ON", the media length
input screen will be displayed.
• A notification reading "Media Set Position R" will appear after media width detection if the
media is too far to the right of the specified position. Reload media in the specified
position.
17
Load an empty paper core on the take-up unit.
To Next Page
Loading...
