Chapter 2 Printing
59
18
Secure the media to the take-up unit.
(1) Press to feed the media until it reaches the core on the take-up unit.
(2) Secure the middle of the media with adhesive tape.
(3) Secure the media on the right and left in the same way.
• Pull the lower edge of the media evenly on both the left and right sides, check to confirm that
it is free of sagging and creasing, then affix the tape.
• Move the take-up unit to the left or right when it is not in use. Print quality may be affected
if the front edge of the media hits the take-up unit.
2
To Next Page
Loading...
