Chapter 3 Settings
79
6
Select the "head number and nozzle row" for nozzle recovery, then press the [ENTER] key.
SELECT ENTRY NOZZLE
Head1-A
>
>
Head1-B
>
Head1-C
>
Head1-D
>><<
>
Head2-A
Head number
Nozzle row number
7
Enter the "nozzle number" for nozzle recovery, then press the [ENTER] key.
• Select the entry number before entering the nozzle number.
• Nozzle recovery is set.
Head2-D
No.1
No.2
16
128
No.3
184
No.4
OFF
No.5
OFF
>><<
Entry number 1 to 10
Nozzle number
8
Press the [ENTER] key once entry is complete.
• Select [Maintenance] > [Nozzle Recovery] > [Test Print], then select “ON” to perform
nozzle recovery and test printing. "Test Printing"(P. 60)
Checking whether nozzle recovery is set correctly
1
Load the media.
2
In LOCAL mode, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
3
Select [Nozzle Recovery] > [Check], then press the [ENTER] key.
• The Judgement screen will be displayed.
4
Enter the desired printing conditions.
Judgement Condition
Resolution
720 x 720
8
PASS
NORMAL
Scan Speed
>
MAPS 4
1
OVER PRINT
3
To Next Page
Loading...
