Chapter 3 Settings
82
Item
Setting
*1
Details
• Standard: Select “Standard” if the medium is not detected
successfully.
LANGUAGE English/
Japanese/
Chinese
Sets the display language.
Time Set -20 h to 0 to
+4 h
Sets the current time and date. (With respect to JST)
• This can be set within the range of -20 to +4 hours.
UNIT / TEMP °C/°F Sets the display unit for temperature (Celsius/Fahrenheit).
UNIT / LENGTH mm/inch Sets the display units for length and area.
• Some items are displayed in “mm” even if “inches” is selected.
Key Buzzer ON/OFF Sets an audible tone when keys are pressed.
• Audible signals indicating errors, warnings, and operation end
cannot be muted, even if “OFF” is selected for this setting.
View Feed ON/OFF Sets whether or not to feed the media forward to view the print
results—for example, during test printing.
Space Btwn PP. None/10 to
500 mm
The space between prints can be eliminated for continuous printing.
• Reducing the space length may cause media sagging, resulting
in discrepancies in the distance the media is fed.
• Depending on the data size and number of passes in the feed
direction, the margins may be wider than the set value.
Space Feed Mode Intermittent/
Continuous
Alters the feed method for blank space included in the image data.
• Intermittent: Uses intermittent feeding based on the timing of a
fraction of the pass.
• Continuous: Feeds forward by skipping blank parts.
Network - Sets the network address. The machine must be restarted to enable
this setting.
Check IP
Address
- Displays the machine’s current IP address.
• It may take some time to determine the IP address. If the IP
address cannot be determined, the display will indicate “0.0.0.0”.
Check MAC
Address
- Displays the machine’s current MAC address.
DHCP ON/OFF Select “ON” to use the IP address assigned by the DHCP server.
AutoIP ON/OFF Select “ON” to use the IP address set by the AutoIP protocol. Note
that DHCP takes priority if DHCP is set to “ON”.
IP Address - Sets the machine’s IP address.
• This can be set when both [DHCP] and [AutoIP] are set to “OFF”.
Default Gateway - Sets the machine’s default gateway.
• This can be set when both [DHCP] and [AutoIP] are set to “OFF”.
DNS Address - Sets the machine’s DNS server address.
• This can be set when both [DHCP] and [AutoIP] are set to “OFF”.
Sub Net Mask - Sets the number of subnet mask digits used by this machine.
• This can be set when both [DHCP] and [AutoIP] are set to “OFF”.
Event Mail - An email can be sent to a specified email address when an event
(e.g., print start, print end, and abort) occurs. The machine must be
restarted to enable this setting. "Event Email Function
Settings"(P. 84)
Mail Delivery ON/OFF Sets whether event emails are sent.
To Next Page
Loading...
