Mindeo FS580 - Example: Configure Scanner

13
4-2 Example: configure scanner
Note: The factory default settings are indicated with asterisks (*) in this manual.
The scanner offers 3 methods to configure scanner: single-scan setting、multiple-scan setting and
command setting.
1、Single-scan setting
Scan the appropriate Single-scan setting barcode according to the user’s demand.
Example: Set Flow control to be none.
Steps: Scan the following barcode.
2、Multiple-scan setting
The steps of configuration are:
a) Scan the SETUP barcode on the parameter setting part.
b) Enter the option mode by scanning the Parameter name barcode.
c) To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan these
alphanumeric entries (see “12 Configuration alphanumeric value barcode”) individually as Para.
Value.
d) Scan the END barcode, listed on the bottom of each parameter setting part.
Notes that only one parameter can be setup at each time.
Example: Set Flow control to be none.
Steps: Scan the following barcodes in order.
3、Command setting
Please refer to “5-13 PARAM_SEND” .