Mindeo FS580 - Page 85

79
For example: Scanner sends NAK.
Length
Opcode
Status
Cause
Checksum
0x04
0x4E
0x00
0x40
(the parameter requested is not exist)
0xFF 0x6E
Table 5-4 describes NAK types supported by the scanner.
Table 4-5 Scanner-supported NAK types
NAK Type
Meaning
Receiver Action
NAK_OVERFLOW
Data Overflow
While receiving message with the baud rate
115200B/s, scanners receive buffer may occur
overflow. If the message length is greater than
7, the scanner fails to receive and process the
data without delay, and reply NAK_OVERFLOW
to host.
NAK_RESEND
Checksum incorrect.
Ensure checksum is correct. Send packet again
with resend bit set (with the retransmit status bit
set).
NAK_BAD_CONTEXT
The parameter want to be changed
do not exist
Do not send the same message again. Ensure
the correct message is sent.
NAK_DENIED
The parameter want to be changed
exceeds the range
NAK_NO_PARA
Host does not recognize the
command.
NAK_OUT_OF_RANGE
Host is unable to comply with the
requested command (e.g., scan
mode setting code is out of range).