Introduction Cautions
x 0070-10-0692-02 Accutorr Plus™ Operating Instructions
CAUTION: It is the users responsibility, when changing the room/bed,
to assure the patient size and alarm settings are as
required.
CAUTION: Do not get the detergent into any vent openings.
CAUTION: Some disinfectants may cause skin irritation. Please rinse
cuff thoroughly with water to remove any residual
disinfectants.
CAUTION: Using dark colored soaks may stain the cuffs. Test a single
cuff to ensure that no damage will occur.
CAUTION: When ironing or pressing the cuffs, be aware that the
Velcro® fasteners can melt at temperatures above 325°F
(162°C).
CAUTION: Cuffs with bladders contain natural rubber latex which may
cause allergic reactions.
CAUTION: When cleaning sensors do not use excessive amounts of
liquid. Wipe the sensor surface with a soft cloth, dampened
with the cleaning solution.
CAUTION: Li-Ion batteries are intended for replacement by qualified
service personnel only.
CAUTION: Batteries used in this device may present a risk of fire or
chemical burn if mistreated. Do not disassemble, heat above
100°C (212°F), or incinerate. Replace Lithium Ion battery
with P/N: 0146-00-0069 only. Use of another battery may
present a risk of fire or explosion.
CAUTION: Dispose of used battery promptly in accordance with local
laws. Keep away from children. Do not disassemble and do
not dispose of in fire.
CAUTION: Recharge the Lithium ion battery while in the unit at room
temperature. If the Accutorr Plus is being used in a hot
environment, the Lithium Ion battery may not charge when
the unit is connected to AC. This safety feature is important
because charging a hot battery shortens the battery’s life
span.
CAUTION: Remove the battery if the Accutorr Plus is not likely to be
used for an extended period of time.
CAUTION: The Communications Connector on the Accutorr Plus is only
for use with IEC 60601-1 compliant equipment.
CAUTION: Removing the battery from the Accutorr Plus while the AC
line cord is disconnected may cause the alarm settings to be
reset to their defaults.