Electromagnetic Compatibility Appendix
6 - 10 0070-10-0692-02 Accutorr Plus™ Operating Instructions
6.3 Electromagnetic Compatibility
Electromagnetic Compatibility
•The Accutorr Plus meets the requirements of IEC 60601-1-2:2001/
EN 60601-1-2:2001.
NOTE: The Accutorr Plus needs special precautions regarding EMC
and needs to be installed and put into service according to
the EMC information provided below.
NOTE: Portable and mobile RF communications equipment can
affect the Accutorr Plus. See TABLE 6-1 through TABLE 6-4.
TABLE 6-1
GUIDANCE AND DECLARATION - ELECTROMAGNETIC EMISSIONS
The Accutorr Plus is intended for use in the electromagnetic environment specified below. The
customer or the user of the Accutorr Plus should assure that it is used in such an environment.
EMISSIONS
TEST COMPLIANCE ELECTROMAGNETIC ENVIRONMENT - GUIDANCE
RF emissions
CISPR 11
Group 1 The Accutorr Plus uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby electronic
equipment.
RF emissions
CISPR 11
Class A The Accutorr Plus is suitable for use in all
establishments other than domestic establishments and
those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic
purposes
Harmonic
emissions IEC
61000-3-2
Class A
Voltage
fluctuations/
Flicker
emissions IEC
61000-3-3
Complies
To Next Page
Loading...
Need help?
General
