Accutorr Plus™ Operating Instructions 0070-10-0692-02 3 - 37
Operation Status and Error Codes
SYSTEM 984* NIBP Hardware Failure NIBP A/D failure detected.
985* NIBP Overpressure Circuit
not Programmed
The overpressure circuit is not set to the
current patient size.
986* NIBP Overpressure Circuit
not Tracking
The two pressure transducers are not
tracking each other.
987* Stop - Hardware
Overpressure
Excessive cuff pressure detected by
hardware over-pressure sensor. A triple
beep tone is generated.
988* TEMP Bad Calibration Thermometer needs calibration.
990* TEMP Illegal Mode Thermometer switch is set wrong.
991* TEMP Module Failed Thermometer internal failure.
995* SpO
2
Uncalibrated SpO
2
fails calibration check.
996* SpO
2
Failure SpO
2
failed self-test.
Status and Error Code Table
TYPE CODE DESCRIPTION REASON
To Next Page
Loading...
Need help?
General
