3 - 2
• Save the packing case and packaging material as they can be used if the
equipment must be reshipped.
• This equipment is in accordance with the EN 1789:2007+A2:2014 standard.
3.2 Environmental Requirements
• Make sure that the equipment operating environment meets the specific
requirements. Otherwise unexpected consequences, e.g. damage to the
equipment, could result.
3.3 Installation
• Check the medical supply unit and IV pole for stability before mounting the
pumps.
• Install a single pole clamp to each pump before mounting the stacked pumps
to the medical supply unit or IV pole.
• A maximum of three pumps can be stacked together when used with the
stack rack.
3.3.1 Installing the Drop Sensor
• To ensure that the pump operates properly, the drop sensor should be
properly installed when d/min is switched on.
• To avoid mistakenly triggering the Empty alarm, adjust the rate to lower than
400ml/h when using the infusion set of 60 drops/ml.
• After long time infusion, small drops may hang inside the drip chamber.
These small drops should be eliminated, Otherwise, they may affect the drop
detection accuracy and cause the Empty alarm.
• The liquid surface in the drip chamber should be lower than the lower edge
of the drop sensor, and lies between the one third and a half of the drip
chamber.
To Next Page
Loading...
Need help?
General
