8 - 1
8 Infusion Modes
• The BeneFusion uVP ex do not provide the Loading Dose Mode.
8.1 Rate Mode/Time Mode
• When infusing in the rate mode and time mode, you must set rate, but time
and VTBI settings are optional.
8.2 Drip Mode
• When infusing in the drip mode, you must set rate, but time and VTBI settings
are optional.
8.3 Dose Mode
• Rate and time can only be obtained by calculation. They are not available for
manual input.
• In the dose mode, the supported dose rate units are X/kg/min, X/kg/h, and X/
kg/24h, in which X represents ng, ug, mg, g, mU, U, kU, EU, mmol, mol, mcal,
cal, kcal, and mEq.
• Some departments, for example the Neonatology, may use fixed drug
amounts, diluent volumes, or concentrations. Using the drug info library to
predefine these infusion parameters can simplify the setting process.
8.4 Loading Dose Mode
To Next Page
Loading...