Image Optimization 5-47
5.12.6 iLive
iLive brings you a better imaging experience by adding a light rendering effect to the
traditional method. It supports the global lighting mode as well as the partial scattering mode,
allowing human tissue texture to be revealed more clearly.
iLive is an option, and is available under Smart 3D, Static 3D and 4D modes. To use the
iLive function, you must configure the Smart 3D module or the 4D module.
To Activate iLive
1. Enter 3D/4D image viewing status, or double-click the saved 3D/4D cine file in the
iStation or Review screen.
2. Select the render mode to be iLive on the screen, and adjust the parameters.
Imaging using iLive
1. Select the imaging mode:
Use the ordinary probe and press <3D/4D> to enter Smart 3D.
Or, use 4D probe and press <3D/4D> twice to enter 4D mode or Static 3D mode.
2. Select the render mode to be iLive on the screen, and set the related parameters
(quality and angle, etc.).
3. Press <Update> to begin acquisition.
4. The system finishes acquisition and enters the image viewing screen.
In image review status, you can perform operations such as VOI setting, image editing,
comment adding, body mark adding, etc.
5. Or press <B> or <3D/4D> to exit the mode.
To Next Page
Loading...
