Mindray DP-50 PT - Image; Application

11-4 Setup
Type
Item
Description
Exam Setup
Status after exam
ends
Select to enter the imaging scanning, patient info or the
Worklist after ending an exam.
Display
Color temperature
Cold/ Warm
Brightness/Contrast
Load Factory
Load the factory data of the display brightness and
contrast.
11.1.3 Image
Open the Image Preset page via [Setup]-> [System Preset]-> [Image], as shown in the figure
below.
Type
Item
Description
Reset Config
Probe
To set the default probe model for the system.
/
MITI
To set MI TI indexes displayed for current probe/exam
mode.
Freeze
Config
Status after Freeze
To set the system status after the image is frozen.
Image
Cine Memory
To set the cine memory splitting type: Auto, Split.
IP
To set the image parameters
11.1.4 Application
Open the Application page via [Setup]-> [System Preset]-> [Application]. Through the page,
you can set the measure ruler, follicle and relevant information. For details, please refer to
the Operator’s Manual [Advanced Volume]