Mindray DP-50 PT - General

Setup 11-3
11.1.2 General
Open the General page via [Setup]-> [System Preset]-> [General], as shown in the figure
below.
Type
Item
Description
Patient Info
Patient Banner
Display Content
To select if to display the following patient information
on the image banner: Gender, Age, Operator, ID,
Name, Hospital Name
H&W Unit
To set the unit for patient height and weight.
Surface Formula
To set the surface formula.
Storage
Image Output Size
To set the size for a stored image:
Image Area
Standard Area
Full Screen
Clip length/ Time (s)
Times: 1~60s
Output Mode
PAL/ NTSC
Patient
Management
Sending/printing
after End Exam
Select if to automatically archive the exam data to
DICOM server for storage/print.
Screen
Saver
Enable
ScreenSaver
To enable screen saver function, and select the waiting
time until screen saver.
Enable Standby
Available after “Enable ScreenSaver” is selected.
Select Picture
After the screen saver function is enabled, click
[Browse] to select the figure used for the screen saver
and click [Preview] to see the effect.