Mindray DP-50 PT - Select Exam Mode and Probe; Supported Exam Modes; Selecting Exam Mode and Probe

Exam Preparation 4-7
 Select exam date period, click [Query] to search the patient data in the period.
 Enter patient ID, patient name, accession #, the system affords the result in real-time.
 Or select the keyword type, enter the keywords and then click [Query] to search.
 To reset the criteria, click [Clear] button.
3. Select the desired patient from the list.
 Click [Start Exam], the patient information is imported into the system and then an
exam is started.
 Click [Transfer], the patient information is imported into the Patient Info screen. Edit
the patient information in the Patient Info screen, and select [OK] to start a new exam.
 Click [Show Detail] to see details of patient data.
4. Click [Exit] to exit the Worklist.
4.3 Select Exam Mode and Probe
CAUTION:
If the exam mode is changed during a measurement, all
measurement calipers on the image will be cleared. The data of
general measurements will be lost, but the data of application
measurements will be stored in the reports.
4.3.1 Supported Exam Modes
The system supports to preset application type, measurements, comments, body marks,
image parameters for each exam mode (including user-defined exam modes). For details,
please refer to “11.2 Exam Preset”.
You can select exam modes for the probes. For details, please refer to “11.2 Exam Preset”.
4.3.2 Selecting Exam Mode and Probe
 Select Probe and Exam Mode
(1) Press <Probe> to open the following dialog box.