2. Safety instructions | 9
2 Safety instructions
2.1 General instructions
CAUTION
Warning of personal injury.
This device has been built and tested in compliance with the
safety regulations for measuring and control equipment for
protection class I (protective grounding conductor) according to
IEC 1010/EN 61010 or VDE 0411.
The device was in perfect condition with regard to safety features
when it left the factory.
To maintain this condition and to ensure safe operation, the
user must follow the instructions and observe the warnings in
this manual.
2.2 Intended use
The device is intended for use of the indicator for weighing functions.
Device operation, commissioning and maintenance must be performed by
trained and qualified personnel who are aware of and able to deal with the
related hazards and take suitable measures for self-protection.
The device reflects the state of the art.
No warranty is given that the device is free of faults, especially not in
conjunction with third-party software and hardware components required for
operation.
The manufacturer does not accept any liability for damage caused by third-
party system components or due to incorrect use of the device. The use of
this device signifies recognition of the stipulations listed above.
2.3 Initial inspection
Check the contents of the consignment for completeness. Check the contents
visually to determine whether any damage has occurred during transport.
If there are grounds for rejection of the goods, a claim must be filed with the
carrier immediately. A MinebeaIntec sales or service organization must also
be notified.
To Next Page
Loading...
Need help?
General
