2. Safety instructions | 2.4 - Before operational startup | 14
2.4.5 RF interference suppression
The device is intended for use in an industrial environment. Operation of this
device in a residential environment is likely to cause radio frequency interfer
ence, see ChapterRF interference suppression. In this case, the operator may
be required to take appropriate measures.
2.4.6 Failure and excessive stress
If there is any reason to assume that safe operation of the device is no longer
ensured, shut it down and make sure it cannot be used.
Safe operation is no longer ensured if any of the following is true:
– The device is physically damaged.
– The device does not function.
– The device has been subjected to stresses beyond the tolerance limits
(e.g., during storage or transport).
2.4.7 Important note
Make sure that the construction of the device is not altered to the detriment
of safety. In particular, leakage paths, air gaps (of live parts) and insulating
layers must not be reduced.
MinebeaIntec cannot be held responsible for personal injury or property
damage caused by a device repaired incorrectly by an operator or installer.
2.4.8 Repairs and maintenance
2.4.8.1 General information
Repairs are subject to inspection and must be carried out at MinebeaIntec.
In case of defect or malfunction, please contact your local MinebeaIntec
dealer or service center for repair.
When returning the device for repair, please include a precise and complete
description of the problem.
Maintenance work may only be carried out by authorized technical personnel
with expert knowledge of the hazards involved and the required precautions.
To Next Page
Loading...
Need help?
General
