CONTENTS
56
Ground Balance (Continued)
MANUAL GROUND BALANCE
Ground Balance can be manually adjusted until the
minimum amount of ground signal is present.
Manual Ground Balance Procedure
1. Navigate to Ground Balance:
Settings > Ground Balance
2. Raise and lower the Coil repeatedly over a clear patch of
soil that does not contain any targets.
3. Listen to the audio response to interpret the result
of the Ground Balance; a low tone indicates that you
should increase the Ground Balance value and a high
tone indicates that you should decrease it.
4. Press / to manually change the Ground Balance value
until the minimum amount of ground signal is heard.
NOTE: Tracking Ground Balance will be automatically
turned Off if Ground Balance is adjusted manually.
TRACKING GROUND BALANCE
Tracking Ground Balance continuously monitors the ground
signal and adjusts the Ground Balance setting to ensure it
is always set correctly. This is useful in locations where the
ground signals are constantly changing, so you don't have
to continually perform a Ground Balance.
Tracking Ground Balance is the default and recommended
Ground Balance method for Beach Surf & Seawater
mode and Goldfield General mode. It effectively manages
the constantly changing conditions in salt-water and
mineralised goldfield soils.
Turn Tracking Ground Balance On/Off
1. Navigate to Ground Balance:
Settings > Ground Balance
2. Press the Right Soft Key (
Tracking) to turn Tracking
Ground Balance On/Off.
When Tracking is On, the Tracking icon (
) is displayed
in the Status Bar.
NOTE: Tracking Ground Balance will be automatically
turned Off if Ground Balance is adjusted manually.
The Ground Balance value
will update automatically
as it tracks to changing
ground conditions.
To Next Page
Loading...
