Mini?Cam SoloPro+ CCU210 - Initial Setup and Preparation; First Use Procedures

Mini-Cam CCU210
Preparing the CCU for First Use
This section describes the process of getting the SOLOPro
+
pipeline inspection
system ready to use when you have just received it.
Initial Inspection
Inspect the shipping container for damage. If the shipping container or
cushioning material is damaged, keep it until you have verified that the contents
are complete and you have tested your SOLOPro
+
Pipeline Inspection System
mechanically and electrically.
The accessory case contains the accessories shipped with the SOLOPro
+
Pipeline
Inspection System. If the contents of the accessory case are incomplete or if the
SOLOPro
+
Pipeline Inspection System does not operate as you would expect,
notify Mini-Cam or your nearest Mini-Cam Service Centre. If the shipping
container is damaged or the cushioning material shows signs of stress, also notify
the carrier. Keep the shipping materials for the carrier’s inspection.
Mini-Cam
or the Mini-Cam Service Centre will arrange for repair or replacement without
waiting for a claim settlement. If the shipping materials are in good condition,
retain them for possible future use. You may wish to ship your SOLOPro+
Pipeline Inspection System to another location or return it to Mini-Cam or your
nearest approved Mini-Cam Service Centre for service.
Power Supplies
The SOLOPro
+
Pipeline Inspection System will operate from an external 12volt
or 24volt DC power source or from internal batteries. The external power source
will also charge the internal batteries when connected. Operating the unit while
the batteries are being charged has no effect whatsoever on the time taken to
recharge the batteries.
The external power source must be 12 volts DC nominal and the unit may
consume up to 2.5 amps if operated while the internal batteries are being
charged.
Battery Charging
When you receive your SOLOPro
+
Pipeline Inspection System, the batteries will
be in a partially discharged state. It is recommended that the unit is fully charged
before use. The equipment may be used while the batteries are being charged
from a mains or vehicle battery supply, but should not be used on internal
battery supply until the batteries have been fully charged. To charge the batteries,
23
Version G