12 GETTING UP AND RUNNING
GETTING UP AND RUNNING
INSTALLING BATTERIES
This digital camera uses two AA-size alkaline or Ni-MH batteries or one CR-V3 lithium battery. Do
not use other types of AA-size batteries. When using Ni-MH batteries, fully recharge them with a bat-
tery charger suitable for complex electronic equipment. Before using the batteries, read the safety
warnings on page 3 of this manual.
When replacing the batteries, the camera should be turned off.
Open the battery-chamber door on the bottom of the camera
by sliding the door toward the side of the camera (1) to
release the safety catch; the door can then be opened (2).
Insert the batteries as shown (3). Never force the batteries.
Close the battery-chamber door (4) and slide it toward the
body (5) to engage the safety catch.
The camera will reset if the batteries are removed for an
extended period. An internal battery protects the clock,
calendar, and camera settings for about 7 days if the
camera is used for at least two days before the batter-
ies are removed.
Camera Notes
+
-
1
2
3
4
5
To Next Page
Loading...
Need help?
General
