17
Turn the camera on by pressing the main switch near the shutter-release button
(1).
TURNING POWER ON
Setting to the playback mode
Captured images can be viewed in the playback mode. Slide the mode switch to the playback posi-
tion. Select the playback mode from single-frame, continuous advance, or movie clips (p. 50).
Setting to the setup mode
The setup mode is used to control the camera’s operation.You can access the setup mode in either
the recording or playback mode (p. 64).
Tur ning power off
After using the camera, turn the camera off by pressing the main switch.
Setting to the recording mode
To capture images, slide the mode switch to the recording
position or viewfinder recording position (2). The lens cover
opens and at first the red indicator lamp blinks, and then the
green indicator lamp glows steadily (3). Set to the recording
position when using the LCD monitor; an image appears on
the monitor when you set to this position. Set to the viewfind-
er recording position when using the viewfinder; this position
will help conserve battery power. Using the menu button and
controller, select the drive mode from single-frame advance,
continuous advance, or movie recording. See recording section on
page 22 for details.
Viewfinder recording mode (p. 22)
Recording mode (p. 22)
Playback mode (p. 50)
1
2
3
To Next Page
Loading...
Need help?
General
