Minolta DIMAGE SCAN DUAL II AF-2820U User Manual

Dimâge Scan Dual II 101
TROUBLE SHOOTING
•Load film into the film holder.
•Scanner door opened during setup. Close
scanner door.
The computer will not start up after
connecting the scanner.
•Shut down the computer and all the
devices in your USB chain, then check the
USB cables and AC power adapter cord.
DS_Dual2 does not appear in the
Import drop down list.
•Make sure the plug-in module has been
placed in the correct folder. See page 21.
“Could not establish connection with
scanner.”
•Indicator lamp is off – Turn the Dimâge
Scan Dual2 on, then restart your system.
“Setting up now. Remove the film
holder.”
•Remove the film holder and click on OK.
“Set film properly…”
Indicator lamp blinking rapidly (8Hz).
“Set 35mm film holder properly.” •Set the correct film type.
“Set APS film holder properly.” •Set the correct film type.
“Could not recognise the film type.” •Set the film type manually.
“Insufficient Memory” •Increase the memory requirements for the
host application.
•If you have scanned multiple images, close
and relaunch the host application.
“Setting up now. Remove the film
holder.” appears when the film
holder is not loaded.
•Contact a Minolta Service Facility to
change the fluorescent lamp.
SYMPTOM or MESSAGE
SOLUTION

Minolta DIMAGE SCAN DUAL II AF-2820U Specifications

General

Brand	Minolta
Model	DIMAGE SCAN DUAL II AF-2820U
Category	Scanner
Language	English