Minolta EP1030 - J-Display; Paper Misfeed

right
Module: Q:\Products\Minolta\e\EP1030\OM\00-gb\Gb\CHAPTER5.GB Page 55 of 60
Text produced for: User Manual EP1030/1030F first page in draft 27
5.6 J-Display
Rev. 1.x/22.05.02 55 EP1030/EP1030F
Chapter 5
5.6 J-Display
This indicates that a paper misfeed has occurred during copying and that
the copier has been stopped.When the Front Door is opened to remove
the paper misfeed, the copier is shut down and all information on the
Control Panel will go out. Therefore, it is necessary to first check for the
location of the paper misfeed before opening the door.
Paper Misfeed
 At this time, "J" and a number will flash alternately on the Display
Panel.
 The number represents the location of the paper misfeed.
Code Cause
There is a paper misfeed in the paper take-up area
of the copier.(See page 56.)
There is a paper misfeed in the paper exit section of
the copier.(See page 56.)
There is a paper misfeed in the Semi-automatic
Document Handler (SDH). (On models equipped
with the SDH.) (See page 58.)