right
Module: Q:\Products\Minolta\e\EP1030\OM\00-gb\Gb\CHAPTER6.GB Page 63 of 64
Text produced for: User Manual EP1030/1030F first page in draft 41
6.1 When This Type of Copy is Produced
Rev. 1.x/22.05.02 63 EP1030/1030F
Chapter 6
The copy has
dark specks or
spots.
The Original Glass is
dirty.
Wipe the Original Glass
clean with a soft dry cloth.
(See page 70.)
The Original Pad or
SDH pad is dirty.
Wipe the Original Pad or
SDH pad clean with a soft
cloth dampened with mild
detergent. (See page 70.)
The Original is very
thin or highly
transparent.
Place a blank sheet of
paper over the original.
(See page 18.)
The information on
the back side of a
two-sided, thin
original may be
slightly reproduced on
the copy.
Set the copier into the
Manual Exposure mode
and make the exposure
level lighter.
(See page 22.)
The edge of the
copy is dirty.
The Original Pad or
SDH Pad is dirty.
Wipe the Original Pad or
SDH pad clean with a soft
cloth dampened with mild
detergent. (See page 70.)
Youhaveselecteda
paper size larger than
the original.
Select the same copy
paper size as the original.
The original is not
placed in the correct
position.
Reposition the original, or
reload the paper in the
same direction as the
original.
The image on
thecopyisnot
aligned properly.
The original is not
placed in the correct
position.
Place the original correctly
on the Original Glass.
(See page 18.)
Or,loaditontotheSDH
correctly along the Guide
Plates. (See page 18.)
The originals may not
be suitable for use in
the SDH.
Raise the SDH and place
the originals on the
Original Glass one at a
time. (See page 19.)
Symptom Possible Cause Action
To Next Page
Loading...
