Rev.3.3 User Manual Page 17 of 299
8. CARE AND CLEANING
SMART ONE is a device that requires little maintenance. The following operations are to be
performed regularly:
• Cleaning and disinfection of the turbine
• Cleaning and disinfection of the mouthpiece
• Cleaning of the device
• Replacing batteries
8.1 Cleaning and disinfection of the turbine
To avoid irreparable damage to the turbine, do not use any alcoholic or oily cleaning solutions, and
do not immerse in hot water or solutions. Do not try to sterilize the turbine in boiling water. Never
try to clean the turbine under a direct jet of water or other liquids. If there are no liquid detergents,
the turbine must at least be washed in clean water.
Correct operation of the turbine is guaranteed only if it is "clean" and free of foreign objects that
affect its movement. The presence of dust or foreign bodies (such as hairs, sputum etc.) could
slow or block the moving parts of the turbine and make the result less accurate or damage the
turbine itself. After each use, check the cleanliness of the turbine.
To clean the turbine, pull it out of the SMART ONE socket by turning it counterclockwise and
simply pulling it out. To make it easier to pull out, push the base of the turbine gently with a finger.
Weekly cleaning is recommended. Immerse the turbine flowmeter in warmy soapy water and
agitate the turbine for 2-3 minutes.
The hand dishwashing detergent that was tested includes these ingredients: Aqua, coco glucoside,
myristyl glucoside, lauryl glucoside, sodium chloride, sodium gluconate, sodium citrate, allyl
caproate, ethylene brassylate, methyldihydrojasmonate).
Rinse in clean water and shake gently to remove any excess water. Allow to air dry on a towel.
Store in a clean, dry place in your home.
To Next Page
Loading...
