104
(6) Setting procedure
The setting procedure for the main A/D converter module is as follows:
1. Set "Method selection" to "Parameter write".
"CC IE Field Configuration" window Select the main A/D converter module from "List of stations"
[CC IE Field Configuration] [Online] [Parameter Processing of Slave Station]
2. In "Basic module parameter", set "CH A/D conversion enable/disable setting" to "0: Enable".
3. In "Basic module parameter", set "CH Input signal error detection setting" to "4: Disconnection
detection".
For the extension A/D converter module, make the settings for each item of "Ext. module 1_Module parameter".
To Next Page
Loading...
