Mitsubishi Electric NZ2EX2B-60AD4 - Chapter 4 Procedures before Operation

46
CHAPTER 4 PROCEDURES BEFORE OPERATION
This chapter describes the procedures before operation.
*1 To replace the module, refer to the point below.
To replace the module, follow the procedure described below:
• Turn off the module power supply and remove the A/D converter module.
• Prepare a new A/D converter module and follow the illustration above as instructed from "Setting a station
number" to "Parameter settings and programming". (No re-setting of network parameters of the master station is
required.)
• If necessary to use the user range, perform the offset/gain setting.
• Carry out operation check and then restart the control.

Page 50, Section 6.1

Page 51, Section 6.2
Page 53, Section 6.3

Page 53, Section 6.3
Page 58, Section 6.4
Page 60, Section 6.5

Page 69, Section 7.1
Page 76, Section 7.2
*1
Page 155, CHAPTER 9
 Page 83, Section 7.3
Set the station number of the main A/D converter module.
Setting a station number
Check box
Connection
When using an extension module, connect the extension module to the
main A/D converter module.
After that, mount the main A/D converter module on a DIN rail.
Carry out wiring of a power supply, Ethernet cables, and external
devices to the main A/D converter module.
To use an extension module, carry out wiring of a power supply
and external devices to the extension module.
Wiring
Parameter settings and programming
Set parameters and create a program.
Offset/gain setting
If the user range is necessary, set up the offset/gain setting.