45
CHAPTER 3 SPECIFICATIONS
3
3.7 List of Remote Buffer Memory Areas
*1 This value is the value of factory default or the value of initialization by Parameter area initialization command (address:
1002H).
*2 This shows whether reading/writing data from/to a program is possible.
R: Readable
W: Writable
*3 This shows the items enabled by turning on and off Initial data setting request flag (RY9).
(2) Monitor area (address: 0700H to 07FFH)
*1 Value at the time of turning off and on the module power supply or at the time of remote reset.
*2 This shows whether reading/writing data from/to a program is possible.
R: Readable
W: Writable
(3) Module control data area (address: 1200H to 12FFH)
*1 Value at the time of turning off and on the module power supply or at the time of remote reset.
*2 This shows whether reading/writing data from/to a program is possible.
R: Readable
W: Writable
Type
Address
Description
Default
value
*1
Read/Write
*2
Decimal Hexadecimal
Extension module 1
Module-based monitor
data
1792 0700H Extension module identification code 0000H R
1793 0701H CH1 Maximum value 0 R
1794 0702H CH1 Minimum value 0 R
1795 0703H CH2 Maximum value 0 R
1796 0704H CH2 Minimum value 0 R
1797 0705H CH3 Maximum value 0 R
1798 0706H CH3 Minimum value 0 R
1799 0707H CH4 Maximum value 0 R
1800 0708H CH4 Minimum value 0 R
1801 to 2047 0709H to 07FFH System area
Type
Address
Description
Default
value
*1
Read/Write
*2
Decimal Hexadecimal
Extension module 1
Module-based control
data
4608 to 4863 1200H to 12FFH System area
To Next Page
Loading...
