116
4. In "Basic module parameter", set the values in "CH Scaling upper limit value" and "CH Scaling
lower limit value".
5. Set CH Shifting amount to conversion value (RWw2 to RWw5) to "2000".
When the shift function, digital clipping function, and scaling function are used together, shift addition is executed on the
value after digital clipping and scale conversion. In this case, the range of the digital operation value is determined as -32768
to 32767.
For a setting example of when the digital clipping function, scaling function, and shift function are used together, refer to the
following:
• Example of the combined use of the digital clipping function, the scaling function, and the shift function ( Page
120, Section 8.13 (4))
To Next Page
Loading...
