Mitsubishi F940GOT Handy Series User Manual

F940GOT Handy Series Introduction 1
1-2
1.1.1 Product Components
1) Operation switches
These switches can be connected to the inputs on the
PLC, when immediate response from the machine
such as operation and stop is required.
Application examples:
• Start/stop
• Preparation for operation
• Setup change
• Error reset
• Mode selection between automatic and manual
Note:
The name of these operation switches can be
personalized using a transparent sheet and a name
label offered as accessories. (Refer to Chapter 4)
2) Display unit
The display unit is touch-key type LCD equivalent to
that of a standard F940GOT.
All functions offered in the standard F940GOT are
available in the Handy GOT. The operator can easily
monitor the ON/OFF status of bit devices in the PLC,
set such bit devices to ON/OFF, monitor the set value
and the current value of word devices, and change
such values of word devices.
This display unit can be used to change the setup, or
set values, and perform troubleshooting, as well as
give system information to the operator.
Application examples:
• Manual operation
• One-cycle operation
• Monitoring
• Forcing devices ON and OFF
• Change of set values
• Troubleshooting
POW ER GRIP SW
Em ergency stop sw itch
D isplay unit
O peration
sw itches
External cable
(option)

Mitsubishi F940GOT Handy Series Specifications

General

Brand	Mitsubishi
Model	F940GOT Handy Series
Category	Control Panel
Language	English